---

name: scienceworld-conductivity-tester description: Determines if an object is electrically conductive by integrating it into a circuit and observing a light bulb. Triggered when classifying an object based on conductivity.

Instructions

Objective

Classify a target object as electrically conductive or non-conductive by using it to complete a simple circuit with a battery and a light bulb.

Core Procedure

1. Locate & Acquire Object: Teleport to the object's location and pick it up.
2. Focus on Object: Use the focus action on the object to signal intent.
3. Setup in Workshop: Teleport to the workshop. Place the object down.
4. Construct Test Circuit: Assemble the circuit on the table in this exact sequence: a. Connect the battery anode to orange wire terminal 1. b. Connect the battery cathode to yellow wire terminal 1. c. Connect orange wire terminal 2 to the blue light bulb cathode. d. Connect green wire terminal 2 to the blue light bulb anode. e. Connect yellow wire terminal 2 to terminal 1 on the target object. f. Connect green wire terminal 1 to terminal 2 on the target object.
5. Observe & Classify: Wait 2 steps (wait1 twice). Then look around.
   • If the blue light bulb is ON, the object is conductive. Place it in the blue box.
   • If the blue light bulb is OFF, the object is non-conductive. Place it in the orange box.

Key Notes

• The workshop contains all necessary components: battery, wires (orange, yellow, green), and light bulbs.
• The circuit is fragile; connect components in the order specified.
• The observation (look around) after waiting is critical for determining the bulb's state.
• This skill assumes the environment's action set and room structure as provided in the trajectory.